×

How to Change the Gas in Your Troy-Bilt Edger

Length of clip: 1:02
This video will show you how to change the gas on this Troy-Bilt edger.  Depending on your model, the instructions in this video may vary slightly.  Always be sure to check your operator's manual for detailed instructions.

Instructions

Step 1

Disconnect the spark plug ignition wire.

Step 2

Unscrew the gas cap.

Step 3

Using the Arnold Siphon Pump, place the top hose into the gas tank on the engine and the bottom hose into a proper container.

Step 4

Prime the pump by pumping the handle three to four times. Once the liquid begins to flow, it will flow without further pumping.

Step 5

Remove the Arnold Siphon Pumpand add new gas.

Step 6

Replace the gas cap.

Step 7

Reconnect the spark plug ignition wire.

Step 8

Dispose of gas properly.

Print This Article

Did You Find this Helpful?    
| P1 |