How to Change the Spark Plug on a Self-Propelled Mower

Before you start this project, make sure you have the correct spark plug.  Many plugs look alike, so refer to the Engine Operator's Manual to ensure that you have the correct spark plug for your engine.  Depending on your model number, the instructions listed below might vary slightly.


Note: The engine should be cool before starting this project.

Instructions

Step 1

Begin by disconnecting the spark plug wire.

Step 2

Using a spark plug wrench and turning counter-clockwise, remove the old spark plug from the mower.  Check the gap on the new spark plug.  Use a specialized gap tool or a set of feeler gauges to adjust the gap.  Refer to the manual for the correct gap.

Step 3

Install the new spark plug, being careful not to cross-thread the plug.  You should be able to thread it in smoothly by hand for a few turns.

Step 4

Using the spark plug wrench, continue tightening.  Make sure the plug is in firmly, but do NOT over-tighten it.

Step 5

Reconnect the spark plug wire and you're good to go.

Parts Finder



Don't know your part or model #?

You can use the PartFinder to help find your model and the right part for your machine.

>Find Matching Models



Did you find this helpful?