Instructions

Step 1

Release both the Auger Control and the Drive Control.

Step 2

Stop the engine by removing the ignition key.

Step 3

Remove the clean-out tool from the clip which secures it to the rear of the auger housing (location may vary by model).

Step 4

Use the shovel-shaped end of the clean-out tool to dislodge and scoop any snow and ice which has formed in and near the chute.

Step 5

Refasten the clean-out tool to the mounting clip.  Reinsert the ignition key and start the snow thrower's engine.

Step 6

While standing in the operator's position (behind the snow thrower), engage the auger control for a few seconds to clear any remaining snow and ice from the chute assembly.

Parts Finder



Don't know your part or model #?

You can use the PartFinder to help find your model and the right part for your machine.

>Find Matching Models



Did you find this helpful?    
×